Downloading Via The Serial Port - Enterasys N Standalone (NSA) Series Configuration Manual

2.2.5.1 Downloading from an FTP or TFTP Server
To perform an FTP or TFTP download, proceed as follows:
1. If you have not already done so, set the device's IP address using the set ip address command
as detailed in Section
2. Download a new image file using the copy command as detailed in
You can now set the device to load the new image file at startup using the set boot system command
as described in Section
2.2.5.2

Downloading via the Serial Port

To download device firmware via the serial (console) port, proceed as follows:
1. With the console port connected, power up the device. The following message displays:
Boot ROM Initialization, Version 01.00.01
Copyright (c) 2004 Enterasys Networks, Inc.
SDRAM size: 128 MB
Testing SDRAM....
Loading Boot Image: 01.00.02...
Uncompressing Boot Image...
Press any key to enter System Image Loader menu
2. Before the boot up completes, press any key. The following boot menu options screen displays.
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM (64KB).
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Run Flash Diagnostics
7 - Update Boot Code
8 - Delete operational code
9 - Reset the system
10 - Restore Configuration to factory defaults (delete config files)
2.2.3.2.
2.2.6.2.
General Configuration Command Set
Downloading a New Firmware Image
PASSED.
DONE.
DONE.
Matrix NSA Series Configuration Guide
Section 2.2.8.5.
2-95