Show Spantree Lp - Enterasys N Standalone (NSA) Series Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Loop Protect Features
6.2.3.2

show spantree lp

Use this command to display the Loop Protect status per port and/or per SID.
show spantree lp [port port-string] [sid sid]
Syntax Description
port-string
sid sid
Command Defaults
If no port-string is specified, status is displayed for all ports.
If no SID is specified, SID 0 is assumed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Loop Protect status on fe.2.3:
Matrix(rw)->show spantree lp port fe.2.3
LoopProtect is enabled on port fe.2.3
6-122 Matrix NSA Series Configuration Guide
(Optional) Specifies port(s) for which to display the Loop
Protect feature status. For a detailed description of possible
port-string values, refer to
(Optional) Specifies the specific Spanning Tree(s) for
which to display the Loop Protect feature status. Valid
values are 0 - 4094. If not specified, SID 0 is assumed.
Section 4.1.1.
, SID 0