Set Physical Alias - Enterasys N Standalone (NSA) Series Configuration Manual

General Configuration Command Set
Setting Basic Device Properties
2.2.3.34

set physical alias

Use this command to set the alias, a text name, for a physical object.
set physical alias {[chassis] [slot slot] [backplane backplane] [module module]
[powersupply powersupply] [powersupply-slot powersupply-slot] [fan]
[fan-slot] [port-string port-string]} [string]
NOTE: Module, slot and certain other hardware-based parameters in the Matrix N
Series Standalone (NSA) CLI support only chassis based N Series devices, such as the
N7, N5, N3 or N1. Executing commands in the NSA CLI with modular parameters not
supported by the standalone will result in an error message.
Syntax Description
chassis
slot slot
backplane
backplane
module module
powersupply
powersupply
powersupply-slot
powersupply-slot
fan
fan-slot
port-string
port-string
string
Command Defaults
If string is not specified, the alias of the type specified will be cleared.
Command Type
Switch command.
2-84 Matrix NSA Series Configuration Guide
Sets an alias for the chassis.
Sets an alias for a specific slot in the chassis.
Sets an alias for the backplane. Valid values are 1 for FTM
1 and 2 for FTM 2.
Sets an alias for a specific module. A maximum of one
module per slot is allowed.
Sets an alias for a specific power supply. Valid values are
1 or 2.
Sets an alias for a specific power supply slot.
Sets an alias for the fan tray.
Sets an alias for the fan tray's slot.
Sets an alias for a specific port.
(Optional) Assigns a text string alias to the specified
physical object.