Enterasys Discovery Protocol - Enterasys N Standalone (NSA) Series Configuration Manual

Discovery Protocols Command Set

Enterasys Discovery Protocol

3.2.2 Enterasys Discovery Protocol
Purpose
To enable and configure the Enterasys Discovery Protocol (CDP), used to discover network
topology. When enabled, CDP allows Enterasys devices to send periodic PDUs about themselves
to neighboring devices.
Commands
The commands used to review and configure the CDP discovery protocol are listed below and
described in the associated section as shown.
•
show cdp (Section
•
set cdp state (Section
•
set cdp auth (Section
•
set cdp interval
•
set cdp hold-time
•
clear cdp (Section
3-4 Matrix NSA Series Configuration Guide
3.2.2.1)
3.2.2.2)
3.2.2.3)
(Section 3.2.2.4)
(Section 3.2.2.5)
3.2.2.6)