Enterasys N Standalone (NSA) Series Configuration Manual page 64

General Configuration Command Set
Managing the Management Authentication Notification MIB
2.2.2.2 set mgmt-auth-notify
Use this command to either enable or disable the Management Authentication Notification MIB.
By selecting the optional Management access type, a user can specifically enable or disable a single
access type, multiple access types or all of the access types. The default setting is that all
Management Authentication Notification types are enabled.
set mgmt-auth-notify {enable | disable}{console | ssh | telnet | web}
NOTE: Insure that SNMP is correctly configured on the DFE in order to send these
notifications, refer to the following chapter for configuring SNMP
Syntax Description
enable
disable
console
ssh
telnet
web
Command Defaults
If none of the optional Management Authentication Access types are entered, than
all authentications types listed above will either be enabled or disabled.
Command Type
Switch command.
Command Mode
Read-Write.
2-38 Matrix NSA Series Configuration Guide
Enable selected or all notifications.
Disable selected or all notifications.
(Optional) console authentications
(Optional) ssh authentications
(Optional) telnet authentications
(Optional) web authentications
(Chapter 5) .