3.2.4.14
set lldp port trap
Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
set lldp port trap {enable | disable} port-string
Syntax Description
enable
disable
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example enables transmitting LLDP traps on ports ge.1.1 through ge.1.6.
Matrix(rw)->set lldp port trap enable ge.1.1-6
Link Layer Discovery Protocol and LLDP-MED
Enable transmitting LLDP traps on the specified ports.
Disable transmitting LLDP traps on the specified ports.
Specifies the port or range of ports to be affected.
Matrix NSA Series Configuration Guide
Discovery Protocols Command Set
3-47