Clear Spantree Adminedge - Enterasys SecureStack B3 Configuration Manual

clear spantree adminedge

Syntax
set spantree adminedge port-string {true | false}
Parameters
port‐string
true | false
Defaults
None.
Mode
Switch command, read‐write.
Usage
The default behavior of the edge port administrative status begins with the value set to false
initially after the device is powered up. If a Spanning Tree BDPU is not received on the port within
a few seconds, the status setting changes to true.
Example
This example shows how to set
B3(su)->set spantree adminedge ge.1.11 true
clear spantree adminedge
Use this command to reset a Spanning Tree port to non‐edge status.
Syntax
clear spantree adminedge port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset
B3(su)->clear spantree adminedge ge.1.11
7-38 Spanning Tree Configuration
Specifies the edge port. For a detailed description of possible port‐string
values, refer to "Port String Syntax Used in the CLI" on page 5‐1.
Enables (true) or disables (false) the specified port as a Spanning Tree edge
port.
.1.11 as an edge port:
ge
Specifies port(s) on which to reset edge port status. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 5‐1.
.1.11 as a non‐edge port:
ge