3.2.4.12
set lldp med-fast-repeat
Network connectivity devices transmit only LLDP TLVs in LLDPDUs until they detect that an
LLDP-MED endpoint device has connected to a port. At that point, the network connectivity device
starts sending LLDP-MED TLVs at a fast start rate on that port. Use this command to set the number
of successive LLDPDUs (with LLDP-MED TLVs) to be sent for one complete fast start interval.
set lldp med-fast-repeat count
Syntax Description
count
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example sets the number of fast start LLDPDUs to be sent to 4.
Matrix(rw)->set lldp med-fast-repeat 4
Link Layer Discovery Protocol and LLDP-MED
Specifies the number of fast start LLDPDUs to be sent
when an LLDP-MED endpoint device is detected. Value
can range from 2 to 10. Default is 3.
Matrix NSA Series Configuration Guide
Discovery Protocols Command Set
3-45