Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.27
show spantree bridgehellomode
Use this command to display the status of bridge hello mode on the device. When enabled, a single
bridge administrative hello time is being used. When disabled, per-port administrative hello times
are being used.
show spantree bridgehellomode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the Spanning Tree bridge hello mode. In this case, a single
bridge hello mode has been enabled using the set spantree bridgehellomode command as
described in
Section
Matrix(rw)->
Bridge Hello Mode is currently enabled.
6-40 Matrix NSA Series Configuration Guide
6.2.1.31:
show spantree bridgehellomode