Enterasys N Standalone (NSA) Series Configuration Manual page 934

IP Configuration Command Set
Reviewing and Configuring the ARP Table
12.2.4.2 arp
Use this command to add or remove permanent (static) ARP table entries. Up to 1,000 static ARP
entries are supported per Matrix Series routing module or standalone device. A multicast MAC
address can be used in a static ARP entry.
arp ip-address mac-address arpa
Syntax Description
ip-address
mac-address
arpa
Command Syntax of the "no" Form
The "no" form of this command removes the specified permanent ARP entry:
no arp ip-address
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to add a permanent ARP entry for the IP address 130.2.3.1 and MAC
address 0003.4712.7a99:
Matrix>Router1(config)#arp 130.2.3.1 0003.4712.7a99 arpa
12-22 Matrix NSA Series Configuration Guide
Specifies the IP address of a device on the network. Valid
values are IP addresses in dotted decimal notation.
Specifies the 48-bit hardware address corresponding to the
ip-address expressed in hexadecimal notation.
Specifies ARPA as the type of ARP mapping.