Set Garp Timer - Enterasys N Standalone (NSA) Series Configuration Manual

VLAN Configuration Command Set
Enabling/Disabling GVRP
7.3.6.5

set garp timer

Use this command to adjust the values of the join, leave, and leaveall timers.
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
NOTE: The setting of these timers is critical and should only be changed by personnel
familiar with the 802.1Q standards documentation, which is not supplied with this
device.
Syntax Description
join timer-value
leave timer-value
leaveall
timer-value
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all ports:
Matrix(rw)->set garp timer join 100 *.*.*
This example shows how to set the leave timer value to 300 centiseconds for all ports:
Matrix(rw)->set garp timer leave 300 *.*.*
7-42 Matrix NSA Series Configuration Guide
Sets the GARP join timer in centiseconds (Refer to 802.1Q
standard.)
Sets the GARP leave timer in centiseconds (Refer to
802.1Q standard.)
Sets the GARP leaveall timer in centiseconds (Refer to
802.1Q standard.)
Specifies the port(s) on which to configure GARP timer
settings. For a detailed description of possible port-string
values, refer to Section 4.1.1.