Clear Ciscodp - Enterasys N Standalone (NSA) Series Configuration Manual

3.2.3.7

clear ciscodp

Use this command to clear the Cisco Discovery Protocol back to the default values.
clear ciscodp { [status | timer | holdtime | port {status | vvid | trust-ext |
cos-ext}] } <port-string>
Syntax Description
status
timer
holdtime
port
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear all the Cisco DP parameters back to the default settings:
Matrix>clear ciscodp
Clear global CiscoDP enable status to default of auto.
Clear the time between CiscoDP PDU transmissions to
default of 60 seconds.
Clear the time-to-live for CiscoDP PDU data to default of
180 seconds.
Clear the CiscoDP port configuration.
status Clear the individual port operational status to the default of
enabled.
vvid Clear the individual port voice VLAN for CiscoDP PDU
transmission to 0.
trust-ext Clear the trust mode configuration of the port to trusted.
cos-ext Clear the CoS priority for untrusted traffic of the port to 0.
Specifies the port(s) on which status will be set. For a
detailed description of possible port-string values, refer to
Section 4.1.1.
Discovery Protocols Command Set
Matrix NSA Series Configuration Guide
Cisco Discovery Protocol
3-23