Set Spantree Maxhops - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.1.52

set spantree maxhops

Use this command to set the Spanning Tree maximum hop count. This is the maximum number of
hops that the information for a particular Spanning Tree instance may traverse (via relay of
BPDUs within the applicable MST region) before being discarded.
set spantree maxhops max_hop_count
Syntax Description
max_hop_count
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the maximum hop count to 40:
Matrix(rw)->
Specifies the maximum number of hops allowed. Valid
values are 0 to 255. Default value is 20.
set spantree maxhops 40
Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix NSA Series Configuration Guide 6-65