Set Lldp Port Med-Trap - Enterasys N Standalone (NSA) Series Configuration Manual

Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3.2.4.15

set lldp port med-trap

Use this command to enable or disable sending an LLDP-MED notification when a change in the
topology has been sensed on the port (that is, a remote endpoint device has been attached or
removed from the port).
set lldp port med-trap {enable | disable} port-string
Syntax Description
enable
disable
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example enables transmitting LLDP-MED traps on ports ge.1.1 through ge.1.6.
Matrix(rw)->set lldp port med-trap enable ge.1.1-6
3-48 Matrix NSA Series Configuration Guide
Enable transmitting LLDP-MED traps on the specified
ports.
Disable transmitting LLDP-MED traps on the specified
ports.
Specifies the port or range of ports to be affected.