Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.6
set spantree stpmode
Use this command to globally enable or disable the Spanning Tree Protocol (STP) mode.
set spantree stpmode {none | ieee8021}
Syntax Description
none
ieee8021
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Spanning Tree:
Matrix(rw)->
6-18 Matrix NSA Series Configuration Guide
Disables Spanning Tree.
Enables 802.1 Spanning Tree mode.
set spantree stpmode none