Configuring Pim - Enterasys N Standalone (NSA) Series Configuration Manual

12.2.7 Configuring PIM

PIM is an advanced routing feature that must be enabled with a license key. If you have purchased
an advanced license key, and have enabled routing on the device, you must activate your license
as described back in
purchase an advanced routing license, contact Enterasys Networks Sales.
Purpose
To review and configure Protocol Independent Multicast (PIM).
Commands
The commands used to review and configure PIM are listed below and described in the associated
section as shown:
•
ip pim sparse mode
•
ip pim bsr-candidate
•
ip pim dr-priority
•
ip pim rp-address
•
ip pim rp-candidate
•
show ip pim bsr
•
show ip pim interface
•
show ip pim neighbor
•
show ip pim rp (Section
•
show ip pim rp-hash
•
show ip mroute (Section
•
show ip mforward
•
show ip rpf (Section
* Advanced License Required *
Section 2.2.4 in order to enable the PIM command set. If you wish to
(Section 12.2.7.1)
(Section 12.2.7.2)
(Section 12.2.7.3)
(Section 12.2.7.4)
(Section 12.2.7.5)
(Section 12.2.7.6)
(Section 12.2.7.7)
(Section 12.2.7.8)
12.2.7.9)
(Section 12.2.7.10)
12.2.7.11)
(Section 12.2.7.12)
12.2.7.13)
IP Configuration Command Set
Matrix NSA Series Configuration Guide
Configuring PIM
12-47