Set Spantree Spanguard - Enterasys N Standalone (NSA) Series Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.55

set spantree spanguard

Use this command to enable or disable the Spanning Tree span guard function. When enabled, this
prevents an unauthorized bridge from becoming part of the active Spanning Tree topology. It does
this by disabling a port that receives a BPDU when that port has been defined as an edge (user) port
(as described in Section
by the set spantree spanguardtimeout
the port is manually unlocked (as described in
set spantree spanguard {enable | disable}
Syntax Description
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the span guard function:
Matrix(rw)->set spantree spanguard enable
6-68 Matrix NSA Series Configuration Guide
6.2.2.20). This port will remain disabled until the amount of time defined
(Section
Enables or disables the span guard function.
6.2.1.58) has passed since the last seen BPDU or
Section 6.2.1.61).