Set Spantree Portpri - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.2.11

set spantree portpri

Use this command to set a port's Spanning Tree priority.
set spantree portpri port-string priority [sid sid]
Syntax Description
port-string
priority
sid sid
Command Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the priority of fe.1.3 to 240 on SID 1:
Matrix(rw)->
Specifies the port(s) for which to set Spanning Tree port
priority. For a detailed description of possible port-string
values, refer to
Specifies a number that represents the priority of a link in
a Spanning Tree bridge. Valid values are from 0 to 240
(in increments of 16) with 0 indicating high priority.
(Optional) Sets port priority for a specific Spanning Tree
identifier. Valid values are 0 - 4094. If not specified, SID
0 is assumed.
set spantree portpri fe.1.3 240 sid 1
Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Section 4.1.1.
Matrix NSA Series Configuration Guide 6-103