Set Snmp Targetparams - Enterasys N Standalone (NSA) Series Configuration Manual

5.3.5.2

set snmp targetparams

Use this command to set SNMP target parameters, a named set of security/authorization criteria
used to generate a message to a target.
set snmp targetparams paramsname user user security-model {v1 | v2c | usm}
message-processing {v1 | v2c | v3} [noauthentication | authentication | privacy]
[volatile | nonvolatile]
Syntax Description
paramsname
user user
security-model v1 |
v2c | usm
message-
processing v1 | v2c
| v3
noauthentication |
authentication |
privacy
volatile |
nonvolatile
Command Defaults
None.
•
•
Command Type
Switch command.
Command Mode
Read-Write.
Specifies a name identifying parameters used to generate
SNMP messages to a particular target.
Specifies an SNMPv1 or v2 community name or an
SNMPv3 user name. Maximum length is 32 bytes.
Specifies the SNMP security model applied to this target
parameter as version 1, 2c or 3 (usm).
Specifies the SNMP message processing model applied to
this target parameter as version 1, 2c or 3.
(Optional) Specifies the SNMP security level applied to
this target parameter as no authentication, authentication
(without privacy) or privacy. Privacy specifies that
messages sent on behalf of the user are protected from
disclosure.
(Optional) Specifies the storage type applied to this target
parameter.
If not specified, security level will be set to noauthentication.
If not specified, storage type will be set to nonvolatile.
SNMP Configuration Command Set
Configuring SNMP Target Parameters
Matrix NSA Series Configuration Guide 5-43