Enterasys N Standalone (NSA) Series Configuration Manual page 129

2.2.7.3 telnet
Use this command to start a Telnet connection to a remote host. The Matrix Series device allows a
total of four inbound and / or outbound Telnet session to run simultaneously.
telnet host [port]
Syntax Description
host
port
Command Defaults
If not specified, the default port number 23 will be used.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to start a Telnet session to a host at 10.21.42.13:
Matrix(rw)->telnet 10.21.42.13
Specifies the name or IP address of the remote host.
(Optional) Specifies the server port number.
Matrix NSA Series Configuration Guide
General Configuration Command Set
Starting and Configuring Telnet
2-103