General Configuration Command Set
Setting Basic Device Properties
2.2.3.21
loop
Use this command to execute a command loop.
loop count [delay] [-r]
Syntax Description
count
delay
-r
Command Defaults
•
•
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to execute a command loop 10 times with a 30 second delay:
Matrix(rw)->loop 10 30
2-70 Matrix NSA Series Configuration Guide
Specifies the number of times to loop. A value of 0 will
make the command loop forever.
(Optional) Specifies the number of seconds to delay
between executions.
(Optional) Refreshes the cursor to the home position on
the screen.
If a delay is not specified, none will be set.
If not specified, the cursor will not refresh.