Purpose
To enable routing interface configuration mode on the device, to create VLAN or loopback routing
interfaces, to review the usability status of interfaces configured for IP, to set IP addresses for
interfaces, and to enable interfaces for IP routing at device startup.
Commands
The commands used to review and configure interface settings are listed below and described in the
associated section as shown:
•
show interface
(Section
•
interface
(Section
•
ip ecm-forwarding-algorithm
•
show ip interface
•
ip address
(Section
•
no shutdown
(Section
12.2.1.1)
12.2.1.2)
(Section
(Section
12.2.1.4)
12.2.1.5)
12.2.1.6)
12.2.1.3)
Matrix NSA Series Configuration Guide
IP Configuration Command Set
Configuring Routing Interface Settings
12-3