General Configuration Command Set
Starting and Configuring Telnet
2.2.7
Starting and Configuring Telnet
Purpose
To enable or disable Telnet, and to start a Telnet session to a remote host. The Matrix Series device
allows a total of four inbound and / or outbound Telnet session to run simultaneously.
Commands
The commands used to enable, start and configure Telnet are listed below and described in the
associated section as shown.
•
show telnet
(Section
•
set telnet
(Section
•
telnet
(Section
2.2.7.3)
•
show router telnet
•
set router telnet
•
clear router telnet
2-100 Matrix NSA Series Configuration Guide
2.2.7.1)
2.2.7.2)
(Section
2.2.7.4)
(Section
2.2.7.5)
(Section
2.2.7.6)