Set Cos Port-Resource Irl - Enterasys N Standalone (NSA) Series Configuration Manual

Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
8.3.3.11

set cos port-resource irl

Use this command to configure a Class of Service inbound rate limiting port resource entry.
set cos port-resource irl group-type-index irl-number {[unit {percentage | kbps
| mbps | gbps}] [rate rate] [type {drop}] [syslog {disable | enable}] [trap
{disable | enable}] [disable-port {disable | enable}]}
Syntax Description
group-type-index
irl-number
unit percentage |
kbps | mbps | gbps
rate rate
type drop
syslog disable |
enable
trap disable |
enable
disable-port
disable | enable
Command Defaults
•
•
•
8-62 Matrix NSA Series Configuration Guide
Specifies an inbound rate limiting port group/type index
for this entry. Valid entries are in the form of group.type.
Group can be 0-7, with 0 designating the default group,
and 1-7 reserved for user-defined groups. Default port
type values cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
Specifies an inbound rate limiter ID to be associated with
this entry.
Specifies the unit of measure as percentage of total
bandwidth, or kilobits, megabits, or gigabits per second.
(Optional) Data rate in units for this inbound rate limiter.
(Optional) Specifies that frames exceeding this limiter
will be dropped.
(Optional) Enables or disables the generation of a Syslog
message when this limiter is exceeded.
(Optional) Enables or disables the sending of an SNMP
trap message when this limiter is exceeded.
(Optional) Enables or disables the disabling of the
violating port when this limiter is exceeded.
If a rate is not specified, port defaults will be applied.
If not specified, frames will not be dropped.
If not specified, Syslog and port disabling will not be configured.