Enterasys N Standalone (NSA) Series Configuration Manual page 171

Table 2-11 Router CLI Configuration Modes (Continued)
Use this mode...
Router
Configuration
Mode
Key Chain
Configuration
Mode
Key Chain Key
Configuration
Mode
Route Map
Configuration
Mode
Policy-Based
Routing
Configuration
Mode
Server Load
Balancing (SLB)
Server Farm
Configuration
Mode
To...
Set IP protocol
parameters.
Set protocol (RIP)
authentication key
parameters.
Configure a specific
key within a RIP
authentication key
chain.
Configure route
maps 1-99.
Configure
policy-based
routing for route
maps 100-199.
Configure an
LSNAT server
farm.
Preparing the Device for Router Mode
Enabling Router Configuration Modes
Access method...
Type router and the
protocol name (and,
for OSPF, the
instance ID) from
Global or Interface
Configuration mode.
Type key chain and
the key chain name
from Router (RIP)
Configuration mode.
Type key and the
key-id from Key
Chain Configuration
Mode.
Type route-map, an
id-number, and
permit or deny from
Global Configuration
Mode.
Type route-map, an
id-number, and
permit or deny from
Global Configuration
Mode.
Type ip slb
serverfarm and the
serverfarmname
from Global
Configuration Mode.
Matrix NSA Series Configuration Guide
Resulting Prompt...
Matrix>Router1
(config-router)#
Matrix>Router1
(config-keychain)#
Matrix>Router1
(config-keychain-key)#
Matrix>Router1
(config-route-map)#
Matrix>Router1
(config-route-map-pbr)#
Matrix>Router1
(config-slb-sfarm)#
2-145