Clear Spantree Adminpathcost - Enterasys N Standalone (NSA) Series Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6.2.2.18

clear spantree adminpathcost

Use this command to reset the Spanning Tree default value for port admin path cost to 0.
clear spantree adminpathcost port-string [sid sid]
Syntax Description
port-string
sid sid
Command Defaults
If sid is not specified, admin path cost will be reset for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the admin path cost to 0 for fe.3.2 on SID 1:
Matrix(rw)->
6-110 Matrix NSA Series Configuration Guide
Specifies the port(s) for which to reset admin path
cost. For a detailed description of possible port-string
values, refer to
(Optional) Resets the admin path cost for specific
Spanning Tree(s). Valid values are 0 - 4094. If not
specified, SID 0 is assumed.
clear spantree adminpathcost fe.3.2 sid 1
Section 4.1.1
.