Table 13-2 OSPF Configuration Task List and Commands (Continued)
To do this...
•
Set a priority to help determine the
OSPF designated router for the
network.
•
Adjust timers and message
intervals.
•
Configure OSPF authentication.
Configure OSPF Areas.
•
Configure an administrative
distance.
•
Define the range of addresses to be
used by Area Boundary Routers
(ABRs).
•
Enable area authentication.
•
Define an area as a stub area.
•
Set the cost value for the default
route that is sent into a stub area.
•
Define an area as an NSSA.
Create virtual links.
Enable passive OSPF mode on an
interface.
Enable redistribution from non-OSPF
routes.
13-32 Matrix NSA Series Configuration Guide
Use these commands...
(Section
(Section
(Section
(Section
(Section
13.2.3.16)
(Section
(Section
13.2.3.18)
(Section
passive-interface
(Section
redistribute
(Section
13.2.3.5)
13.2.3.6)
(Section
13.2.3.7)
(Section
13.2.3.8)
(Section
13.2.3.9)
(Section
13.2.3.10)
(Section
13.2.3.11)
(Section
13.2.3.13)
13.2.3.14)
(Section
13.2.3.15)
13.2.3.17)
13.2.3.19)
13.2.3.20)
13.2.3.21)
13.2.3.12)