Enabling Router Configuration Modes - Enterasys N Standalone (NSA) Series Configuration Manual

Preparing the Device for Router Mode

Enabling Router Configuration Modes

2.3.3 Enabling Router Configuration Modes
The Matrix CLI provides different modes of router operation for issuing a subset of commands from
each mode. Table 2-11
NOTE: The command prompts used as examples in
guide show switch operation for a user in Read-Write (rw) access mode, and a system
where module 1 and VLAN 1 have been configured for routing. The prompt changes
depending on your current configuration mode, the specific module, and the interface
types and numbers configured for routing on your system.
Table 2-11 Router CLI Configuration Modes
Use this mode...
Privileged EXEC
Mode
Global
Configuration
Mode
Interface
Configuration
Mode
2-144 Matrix NSA Series Configuration Guide
describes these modes of operation.
To...
•
Set system
operating
parameters
•
Show
configuration
parameters
•
Save/copy
configurations
Set system-wide
parameters.
Configure router
interfaces.
Table 2-11
Access method...
From the switch CLI:
1. Type router
module (using a
module number
configured for
routing), then
2. Type enable.
Type configure
terminal from
Privileged EXEC
mode.
Type interface vlan
or interface
loopback and the
interface's id from
Global Configuration
mode.
and throughout this
Resulting Prompt...
Matrix>Router1>
Matrix>Router1#
Matrix>Router1(config)#
Matrix>Router1
(config-if(Vlan 1 | Lpbk
1))#