Clear Spantree Priority - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.1.26

clear spantree priority

Use this command to reset the Spanning Tree priority to the default value of 32768.
clear spantree priority [sid]
Syntax Description
sid
Command Defaults
If sid is not specified, priority will be reset on Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the bridge priority on SID 1:
Matrix(rw)->clear spantree priority 1
Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
(Optional) Resets the priority on a specific Spanning
Tree. Valid values are 0 - 4094. If not specified, SID
0 is assumed.
Matrix NSA Series Configuration Guide 6-39