Table of Contents
Advertisement
This chapter describes the Internet Protocol (IP) configuration set of commands and how to use
them.
ROUTER: Unless otherwise noted, the commands covered in this chapter can be
executed only when the device is in router mode. For details on how to enable router
configuration modes, refer to
12.1 PROCESS OVERVIEW: INTERNET PROTOCOL (IP)
CONFIGURATION
Use the following steps as a guide to configuring IP on the device:
1. Configuring routing interface settings
2. Managing router configuration files
3. Performing a basic router configuration
4. Reviewing and configuring the ARP table
5. Reviewing and configuring broadcast settings
6. Reviewing IP traffic and configuring routes
7. Configuring PIM
8. Configuring Load Sharing Network Address Translation (LSNAT)
9. Configuring Dynamic Host Configuration Protocol (DHCP)
Section
(Section
(Section
12.2.7)
IP Configuration
2.3.3.
(Section
12.2.1)
12.2.2)
(Section
12.2.3)
(Section
12.2.4)
(Section
12.2.5)
(Section
12.2.6)
Matrix NSA Series Configuration Guide
12
(Section
12.2.8)
(Section
12.2.9)
12-1
Advertisement
Chapters
Table of Contents
