Set Movedaddrtrap - Enterasys N Standalone (NSA) Series Configuration Manual

Logging And Network Management Command Set
Managing Switch Network Addresses and Routes

11.2.5.17 set movedaddrtrap

Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when moved source MAC addresses are detected.
set movedaddrtrap [port-string] {enable | disable}
Syntax Description
port-string
enable | disable
Command Defaults
If port-string is not specified, MAC address traps will be globally enabled or
disabled.
Command Mode
Read-Write.
Example
This example shows how to globally enable MAC address traps:
Matrix(rw)->
11-120 Matrix NSA Series Configuration Guide
(Optional) Specifies the port(s) on which to enable or
disable MAC address traps. For a detailed description of
possible port-string values, refer to
Enables or disables SNMP trap messaging when moved
source MAC addresses are detected.
set movedaddrtrap enable
Section 4.1.1.