Adding A Physical Interface To A Port Channel - Dell S3048-ON Configuration Manual

no shutdown
After you enable the port channel, you can place it in Layer 2 or Layer 3 mode. To place the port channel in Layer 2 mode or configure an IP
address to place the port channel in Layer 3 mode, use the switchport command.
You can configure a port channel as you would a physical interface by enabling or configuring protocols or assigning access control lists.

Adding a Physical Interface to a Port Channel

The physical interfaces in a port channel can be on any line card in the chassis, but must be the same physical type.
NOTE: Port channels can contain a mix of Ethernet interfaces, but Dell Networking OS disables the interfaces that are not the
same speed of the first channel member in the port channel (refer to
You can add any physical interface to a port channel if the interface configuration is minimal. You can configure only the following
commands on an interface if it is a member of a port channel:
•
description
•
shutdown/no shutdown
•
mtu
• ip mtu (if the interface is on a Jumbo-enabled by default)
NOTE: A logical port channel interface cannot have flow control. Flow control can only be present on the physical interfaces if
they are part of a port channel.
NOTE: The system supports jumbo frames by default (the default maximum transmission unit (MTU) is 1554 bytes). To configure
the MTU, use the mtu command from INTERFACE mode.
To view the interface's configuration, enter INTERFACE mode for that interface and use the show config command or from EXEC
Privilege mode, use the show running-config interface interface command.
When an interface is added to a port channel, Dell Networking OS recalculates the hash algorithm.
To add a physical interface to a port, use the following commands.
1 Add the interface to a port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
The interface variable is the physical interface type and slot/port information.
2 Double check that the interface was added to the port channel.
INTERFACE PORT-CHANNEL mode
show config
Examples of the show interfaces port-channel Commands
To view the port channel's status and channel members in a tabular format, use the show interfaces port-channel brief
command in EXEC Privilege mode, as shown in the following example.
Dell#show int port brief
LAG Mode Status Uptime
1 L2L3 up 00:06:03 Gi 1/6 (Up) *
2 L2L3 up 00:06:03 Gi 1/7 (Up) *
Dell#
Ports
Gi 1/12 (Up)
Gi 1/8 (Up)
Gi 1/13 (Up)
Gi 1/14 (Up)
10/100/1000 Mbps Interfaces in Port Channels).
Interfaces 335