D-Link DXS-3600 Series Reference Manual page 1227

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no switchport access vlan
Parameters
access vlan VLAN-ID
Default
By default, this access VLAN is VLAN 1.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command takes effect when the interface is set to access mode, or dot1q-tunnel mode. The VLAN
specified as the access VLAN does not need to exist to configure the command.
Only one access VLAN can be specified. The succeeding command overwrites the previous command.
Example
This example shows how to configure the interface 1/0/1 to access mode with access VLAN 1000.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 1000
Switch(config-if)#
110-10 switchport hybrid allowed vlan
This command is used to specify the tagged or untagged VLANs for a hybrid port. Use the no form of the
command to reset to the default setting.
switchport hybrid allowed vlan {[add] {tagged | untagged} | remove} VLAN-ID [, | -]
no switchport hybrid allowed vlan
Parameters
add
remove
tagged
untagged
VLAN-ID
,
Specifies the access VLAN of the interface.
Specifies the port will be added into the specified VLAN(s).
Specifies the port will be removed from the specified VLAN(s).
Specifies the port as a tagged member of the specified VLAN(s).
Specifies the port as an untagged member of the specified VLAN(s).
Specified the allowed VLAN list or the VLAN list to be added to or
removed from the allow VLAN list. If no option is specified, the
specified VLAN list will overwrite the allowed VLAN list.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is required before and after the
comma.
1227