D-Link DXS-3600 Series Reference Manual page 1208

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-if)#
109-4 switchport vlan mapping
This command is used to specify the VLAN translation entry for a trunk port or to specify the service
VLAN mapping entry for a dot1q tunnel port. Use the no command to remove the VLAN translation entry
or the service VLAN mapping entry.
switchport vlan mapping original-vlan ORIGINAL-VLAN [, | -] {[ORIGINAL-INNER-VLAN]
resultant–vlan RESULTANT-VLAN [RESULTANT-INNER-VLAN] | dot1q-tunnel DOT1Q-TUNNEL-
VLAN} [priority COS-VALUE]
no switchport vlan mapping original-vlan ORIGINAL-VLAN [, | -] [ORIGINAL-INNER-VLAN]
Parameters
ORIGINAL-VLAN
ORIGINAL-INNER-VLAN
RESULTANT-VLAN
RESULTANT-INNER-VLAN
DOT1Q-TUNNEL-VLAN
COS-VALUE
,
-
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command only takes effect for the port or port-channel that is set to 802.1Q tunnel mode or trunk
mode.
If the dot1q-tunnel parameter is specified in this command, once the C-VLAN tag of the incoming packet
matches the specified original VLAN, the specified S-VLAN is added to make the packet becomes double
tagged. Specify a VLAN range to map multiple original VLANs to single S-VLAN. This rule can be
configured on an 802.1Q tunnel port. Otherwise, the rule will not take effect (its status is inactive).
Specifies the original VLAN ID that will be matched for incoming
packets. The range is from 1 to 4094.
(Optional) Specifies that the original inner VLAN is used to match the
inner VID for incoming packets on the trunk mode port. The range is
from 1 to 4094.
Specifies the translated service VLAN ID. The range is from 1 to 4094.
The service VLAN will replace the original VLAN for matched packets.
(Optional) Specifies the new inner VLAN that will replace original inner
VLAN on trunk mode port.
Specifies the service VLAN ID that will be added for matched packets
on the dot1q-tunnel mode port.
(Optional) Specifies the priority for the rule. If not specified, the priority
of the service VLAN tag will be set to 0.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is allowed before and after the
comma.
(Optional) Specifies a range of VLANs. No space is allowed before and
after the hyphen.
1208