D-Link DXS-3600 Series Reference Manual page 1220

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable ingress checking for packets received by the interface. If ingress checking is
enabled, the packet will be dropped if the received port is not a member port of the VLAN classified for
the received packet.
Example
This example shows how to set ingress checking to enabled port eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ingress-checking
Switch(config-if)#
110-3 mac-vlan
This command is used to create the MAC-based VLAN classification entry. Use the no form of this
command to remove the MAC-based VLAN classification entry.
mac-vlan MAC-ADDRESS vlan VLAN-ID [priority COS-VALUE]
no mac-vlan MAC-ADDRESS
Parameters
MAC-ADDRESS
priority COS-VALUE
VLAN-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to create the MAC-based VLAN classification entry. The classification entry will be
applied to packets received by the switch. By default, the precedence to classify the VLAN for an
untagged packet is MAC-based > Subnet-based > Protocol VLAN.
Example
Specifies the MAC address for the entry.
(Optional) Specifies the priority CoS value. If not specified, the default
CoS is 0.
Specifies the VLAN ID for the MAC-based VLAN entry.
1220