D-Link DXS-3600 Series Reference Manual page 1221

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to create a MAC-based VLAN ID entry for the MAC address 00-80-cc-00-00-11.
Switch# configure terminal
Switch(config)# mac-vlan 00-80-cc-00-00-11 vlan 101 priority 4
Switch(config)#
110-4 protocol-vlan profile
This command is used to create a protocol group. Use the no command to remove the specified protocol
group.
protocol-vlan profile PROFILE-ID frame-type {ethernet2 | snap | llc} ether-type TYPE-VALUE
no protocol-vlan profile PROFILE-ID
Parameters
PROFILE-ID
frame-type
ethernet2
snap
llc
ether-type TYPE-VALUE
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the protocol-vlan profile command in the global configuration mode to create a protocol group.
Then use the protocol-vlan profile command in the interface configuration mode to configure the VLAN
classification for the protocol group received by the port.
Example
This example shows how to create a protocol VLAN group with a group ID of 10, specifying that the IPv6
protocol (frame type is ethernet2 value is 0x86dd) will be used.
Switch# configure terminal
Switch(config)# protocol-vlan profile 10 frame-type ethernet2 ether-type 0x86dd
Switch(config)#
110-5 protocol-vlan profile (interface)
This command is used to configure the VLAN classification entry for a protocol group on a port. Use the
no form of the command to remove the VLAN classification entry on a port.
Specifies the protocol group to add or delete.
Specifies the frame type.
Specifies the value for the type of the Ethernet II frames.
Specifies the value for the type of the SNAP frames.
Specifies the value for the type of the LLC frames.
Specifies the type. This value should be 2 bytes in hexadecimal form.
1221