D-Link DXS-3600 Series Reference Manual page 1232

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
vlan VLAN-ID [, | -]
no vlan VLAN-ID [, | -]
Parameters
VLAN-ID
,
-
Default
The VLAN ID 1 exists in the system as the default VLAN.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the vlan global configuration command to create VLANs. Entering the vlan command with a VLAN
ID enters the VLAN configuration mode. Entering the VLAN ID of an existing VLAN does not create a new
VLAN, but allows the user to modify the VLAN parameters for the specified VLAN. When the user enters
the VLAN ID of a new VLAN, the VLAN will be automatically created.
Use the no vlan command to remove a VLAN. The default VLAN cannot be removed. If the removed
VLAN is a port's access VLAN, the port's access VLAN will be reset to VLAN 1.
Example
This example shows how to add new VLANs, assigning the new VLANs with the VLAN IDs 1000 to 1005.
Switch# configure terminal
Switch(config)# vlan 1000-1005
Switch(config-vlan)#
110-16 vlan precedence
This command is used to specify the VLAN classification precedence for the port. Use no command to
reset the VLAN classification precedence for the port.
vlan precedence {mac-vlan | subnet-vlan}
no vlan precedence
Parameters
mac-vlan
Specifies the ID of the VLAN to be added, removed or configured. The
valid VLAN ID range is from 1 to 4094. VLAN ID 1 cannot be removed.
Specifies a series of VLANs, or separate a range of VLANs from a
previous range. No space is required before and after the comma.
(Optional) Specifies a range of VLANs. No space is required before
and after the hyphen.
Specifies the port MAC-based VLAN classification is precedence than
the subnet-based VLAN.
1232