Ipv6 Mld Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
C-RP Advertisement Interval (secs) ............ 200
The following message will be displayed if no RP Group mapping exists on the router.
No RP-Group mappings exist on this router.
Display Parameters
RP Address
Group Address
Origin
C-RP Advertisement
Interval
Next Candidate RP
Advertisement (hh:mm:ss)

IPv6 MLD Commands

IGMP/MLD Snooping is a type of Layer 2 functionality, but IGMP/MLD consist of Layer 3 multicast
protocols. Their use requires that a network setup should have a multicast router (which can serve as a
querier) present in order to solicit the multicast group registrations. However, some types of network
setups do not require a multicast router because any multicast traffic is intended for hosts within the same
network. In such a situation, D-LINK OS has an IGMP/MLD Snooping Querier that runs on one of the
switches, while Snooping will be enabled on all of the switches. Please see
Configuration Commands"
10-25 ipv6 mld router
When used in administrative mode, the command enables MLD.
When used in the administrative mode, the no command disables MLD.
ipv6 mld router
no ipv6 mld router
Parameters
None
Default
The default is Disabled.
Command Mode
Global Config
The lPv6 address of the RP for the group specified.
The lPv6 address and prefix length of the multicast group.
Indicates the mechanism (BSR or static) by which the RP was selected.
Indicates the configured C-RP Advertisement interval with which the
router acting as a Candidate RP will periodically send the C-RP
advertisement messages to the elected BSR.
Indicates the configured C-RP Advertisement interval with which the
router acting as a Candidate RP sends the C-RP advertisement
messages to the elected BSR based on a scheduled interval.
for more information on this topic.
1007
"IGMP Snooping