Configuring The Ssh Client - H3C S3600 Series Operation Manual

Operation Manual – SSH Terminal Service
H3C S3600 Series Ethernet Switches-Release 1510
Table 1-8 Automatic configuration
Operation
Enter system view
Transform the format of
the key in a client public
key
automatically configure
a client public key on
the server
Note:
The above method does not require you to manually configure a public key. So the
method is relatively simple and is the recommended method.
VII. Specifying a source IP address/interface for the SSH server
You can perform the following configurations to specify a source IP address or a source
interface for the SSH server, thus enhancing traffic manageability.
Table 1-9 Specify a source IP address/interface for the SSH server
Enter system view
Specify
address
server
Specify a source interface
for the SSH server

1.1.3 Configuring the SSH Client

A variety of SSH client software are available, such as PuTTY and OpenSSH. For an
SSH client to establish a connection with an SSH server, you must complete these
configuration tasks:
Specifying the IP address of the server.
Selecting the protocol for remote connection as SSH. Usually, a client can use a
variety of remote connection protocols, such as Telnet, Rlogin, and SSH. To
establish an SSH connection, you must select SSH.
Selecting the SSH version. Since the device supports SSH Server 2.0 now, select
2.0 or lower for the client.
system-view
rsa
file and
keyname
filename
Operation
system-view
a source IP
for the SSH
ssh-server source-ip ip-address
ssh-server
interface-type interface-number
Command
peer-public-key
import sshkey
Command
source-interface
1-11
Chapter 1 SSH Terminal Service
Description
—
filename must
consistent with the name
of a public key file in the
Flash memory.
Description
—
Optional
Optional
be