Table of Contents
Advertisement
Figure 33. Installing the intrusion switch
Next steps
1. Connect the system power cable to the system board.
2.
Install the air
shroud.
3. Follow the procedure listed in
Optional serial COM port
This is a service technician replaceable part only.
Removing the optional serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Disconnect the serial COM port cable from the connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Open the card holder and lift the serial COM port out of the system.
46
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
