Configure The Management Port Ip Address; Configure A Management Route - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Configure the Management Port IP Address

Assign IP addresses to the management ports in order to access the system remotely.
Note: Assign different IP addresses to each RPM's management port.
To configure the management port IP address:
Step
Task
1
Enter INTERFACE mode for the
Management port.
2
Assign an IPv4 or IPv6 address to
the interface.
3
Enable the interface.

Configure a Management Route

Define a path from the system to the network from which you are accessing the system remotely.
Management routes are separate from IP routes and are only used to manage the system through the
management port.
To configure a management route:
Step
Task
Configure an IPv4 or IPv6
1
management route to the network
from which you are accessing the
system.
Configure a Username and Password
Configure a system username and password to access the system remotely.
48
|
Getting Started
Command Syntax
interface ManagementEthernet
slot
range: 0 to 1
range: 0
port
ip address {
ipv4-address
ipv4-address:
an address in dotted-decimal
format (A.B.C.D).
ipv6-address:
an address in hexadecimal format
(X:X:X:X::X).
mask:
a subnet mask in /prefix-length format (/
xx).
no shutdown
Command Syntax
management route
{
ipv4-address
mask gateway
the network address in
ip-address:
dotted-decimal format (A.B.C.D).
a subnet mask in /prefix-length format (/
mask:
xx).
: the next hop for network traffic
gateway
originating from the management port.
slot/port
|
ipv6-address
}
/mask
|
}/
ipv6-address
Command Mode
CONFIGURATION
INTERFACE
INTERFACE
Command Mode
CONFIGURATION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents