Management Route Default - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Command
History
Related
Commands

management route default

Syntax
Parameters
Mode
Command
History
Usage
Information
Example
| System Management Commands
40
Version 2.3
Introduced. Replaces the
interface managementethernet
This command sets the IP gateway of the switch. The management IP address (configured with the ip
address, above) and the gateway must be on the same subnet.
management route default gateway
gateway
Use no management route default to remove the gateway.
Global Config
Version 2.3 Introduced: Replaces the
management address.
Use this command along with the ip address command to configure the management address of the
switch. Execute the interface managementethernet command from Global Config mode to access the
ip address command, as shown in the following example.
Note:
The IP Address and the gateway must be on the same subnet.
Figure 5-5. Example of Configuring Management Address
(s50-1) (Config)#management route default 10.10.1.254
(s50-1) (Config)#interface managementethernet
(Config-if-ma)#ip address 10.10.1.251 255.255.255.0
(Config-if-ma)#exit
(s50-1) (Config)#ip http server enable
(s50-1) (Config)#exit
(s50-1) #
(s50-1) #show interface managementethernet
IP Address..................................... 10.10.1.151
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.10.1.254
Burned In MAC Address.......................... 00:01:E8:D5:A0:39
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Disable
network mac-type
Invokes the Interface ManagementEthernet mode, the
(Config-if-ma)# prompt.
Valid IP address
network parms command for the gateway part of the
command.