Interface Range - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Sftos command reference
Hide thumbs Also See for Force10 S2410-01-10GE-24P:
Table of Contents

Advertisement

interface
This command accesses the Interface Config mode for a designated logical or physical interface. The
Interface Config mode provides access to configuration commands for the specified interface.
interface unit/slot/port
Syntax
The unit/slot/port is a valid physical or logical port number. Physical ports are numbered
#/0/1 through #/0/50. In contrast, logical port numbers contain a number in the slot position and are
defined by the system. The number in the slot position is a 1 when you create a LAG (port channel).
The no version of this command deletes the selected logical port.
Default
None
Mode
Global Config
Related

interface range

Commands
ip address (VLAN)
interface vlan
routing
show ip interface
interface range
This command groups a set of individual interfaces, a range of interfaces, or more than one range of
interfaces, to which subsequent configuration commands can be applied (bulk configuration).
interface range {ethernet range,range ,... | port-channel range,range,... | vlan range , range ,...}
Syntax
ethernet
Parameters
range,range
Groups a set of individual interfaces, a range of interfaces, or more than one range of
interfaces, to which subsequent configuration commands can be applied (bulk
configuration)
Assigns an IP address and subnet mask to the selected VLAN to support Layer 3
routing.
Creates a new VLAN, or selects one based on ID, and then enters the Interface
VLAN mode, which provides access to VLAN configuration commands for the
specified VLAN.
Enables routing for the selected interface
Displays summary information about IP configuration settings for all ports in the
router
ethernet
Enter the keyword
,...
commas in this form:
unit/slot/port
unit/slot/port
-
Spaces are not allowed around commas or hyphens.
You can enter up to six comma-separated ranges.
Example:
ethernet 1/0/1-1/0/10,1/0/40-1/0/45
and one or more ports separated by hyphens and
unit/slot/port
unit/slot/port
,
-
System Configuration Commands | 91

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Force10

Table of Contents