Creating A Qos Interface Hierarchy For Bulk-Configured Vlan Subinterfaces With Radius - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

JUNOSe 11.1.x Quality of Service Configuration Guide
Creating a QoS Interface Hierarchy for Bulk-Configured VLAN Subinterfaces with
RADIUS
Bulk-configured VLAN subinterfaces are created dynamically, so you cannot apply a
QoS profile directly to a VLAN subinterface. Instead, you can use subscriber service
profiles and RADIUS to apply QoS profiles.
To create an interface hierarchy for bulk-configured VLAN subinterfaces:
1.
2.
3.
TIP: Configure the service profile in the default virtual router or the virtual router in
which RADIUS is configured.
4.
5.
180

Creating a QoS Interface Hierarchy for Bulk-Configured VLAN Subinterfaces with RADIUS

Configure the bulk-configured VLAN subinterface.
host1(config)#interface gigabitEthernet 6/0/0
host1(config-if)#encapsulation vlan
host1(config-if)#auto-configure vlan
host1(config-if)#vlan bulk-config BulkConfig
host1(config-if)#profile vlan bulk-config BulkConfig vlanBulkProfile
host1(config-if)#vlan bulk-config BulkConfig vlan-range 1 3600
Configure the profiles and service profile for the bulk-configured VLAN
subinterfaces and the IP upper-layer encapsulation.
host1(config-if)#profile vlanBulkProfile
host1(config-profile)#vlan auto-configure ip
host1(config-profile)#vlan profile ip ipProfile
host1(config-profile)#vlan service-profile vlanServiceProfile
host1(config-profile)#exit
host1(config-profile)#profile ipProfile
host1(config-profile)#ip unnumbered loopback 0
host1(config-profile)#exit
Configure an IP service profile.
host1(config)#ip service-profile vlanServiceProfile
host1(config-service-profile)#user-name "vlan@test"
host1(config-service-profile)#password 56789
host1(config-service-profile)#exit
Access the RADIUS server and assign values for the RADIUS attributes necessary
for creating a QoS interface hierarchy, including the QoS profile name. For
example:
Juniper VSA Qos-Profile-Name [26-26] QoS profile name
(Optional) Juniper VSA Virtual-Router [26-1] Virtual router name
(Optional) IETF VSA [22] Framed-Route
Verify that the attributes are being used by RADIUS.