Creating A Qos Interface Hierarchy For Bulk-Configured Vlan Subinterfaces; With Radius - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

JunosE 11.3.x Quality of Service Configuration Guide
Creating a QoS Interface Hierarchy for Bulk-Configured VLAN Subinterfaces with
RADIUS
172
Bulk-configured VLAN subinterfaces are created dynamically, so you cannot apply a QoS
profile directly to a VLAN subinterface. Instead, you can use subscriber service profiles
and RADIUS to apply QoS profiles.
To create an interface hierarchy for bulk-configured VLAN subinterfaces:
Configure the bulk-configured VLAN subinterface.
1.
host1(config)#interface gigabitEthernet 6/0/0
host1(config-if)#encapsulation vlan
host1(config-if)#auto-configure vlan
host1(config-if)#vlan bulk-config BulkConfig
host1(config-if)#profile vlan bulk-config BulkConfig vlanBulkProfile
host1(config-if)#vlan bulk-config BulkConfig vlan-range 1 3600
Configure the profiles and service profile for the bulk-configured VLAN subinterfaces
2.
and the IP upper-layer encapsulation.
host1(config-if)#profile vlanBulkProfile
host1(config-profile)#vlan auto-configure ip
host1(config-profile)#vlan profile ip ipProfile
host1(config-profile)#vlan service-profile vlanServiceProfile
host1(config-profile)#exit
host1(config-profile)#profile ipProfile
host1(config-profile)#ip unnumbered loopback 0
host1(config-profile)#exit
Configure an IP service profile.
3.
host1(config)#ip service-profile vlanServiceProfile
host1(config-service-profile)#user-name "vlan@test"
host1(config-service-profile)#password 56789
host1(config-service-profile)#exit
TIP: Configure the service profile in the default virtual router or the virtual
router in which RADIUS is configured.
Access the RADIUS server and assign values for the RADIUS attributes necessary for
4.
creating a QoS interface hierarchy, including the QoS profile name. For example:
Juniper VSA Qos-Profile-Name [26-26]—QoS profile name
(Optional) Juniper VSA Virtual-Router [26-1]—Virtual router name
(Optional) IETF VSA [22]—Framed-Route
Verify that the attributes are being used by RADIUS.
5.
The highlighted output from this debug log message shows the QoS profile, virtual
router, and framed route attributes configured through RADIUS.
Copyright © 2010, Juniper Networks, Inc.