Policy Condition Source Port Group - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

QoS Policy Commands

policy condition source port group

Associates a source port group with a policy condition. Use the no form of the command to remove a
source port group from a condition.
policy condition condition_name source port group group_name
policy condition condition_name no source port group
Syntax Definitions
condition_name
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of the command to remove a source port group from a condition; however, at least one
classification parameter must be associated with a condition.
Examples
-> policy condition cond6 source port group portgr4
Release History
Release 6.6.1; command was introduced.
Related Commands
policy port group
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition. May be an existing condition name or a new
condition.
The name of the source port group. Port groups are configured through
the policy port group
Configures a port group and its associated slot and port numbers.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
November 2009
command.
page 39-105