ABB IRB 2600ID Product Manual page 180

3 Maintenance
3.4.7 Changing oil, axes-5 and -6 gearboxes
Continued
Draining axes-5 and -6 gearbox - wrist 12/20 kg
Use this procedure to drain oil from the gearbox.
1
2
3
4
5
6
7
8
Continues on next page
180
CAUTION
The gearbox can contain an excess of pressure that can be hazardous. Open
the oil plug carefully in order to let out the excess pressure.
Action
Move the upper arm to a horizontal position.
IRB 2600:
Turn axis-4 to the calibration position.
IRB 2600ID:
Turn axis-4 +90° so that the oil plug for
filling is on top.
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
WARNING
Handling gearbox oil involves several safety
risks, see Gearbox lubricants (oil or grease)
on page 36.
Remove the oil plugs in the wrist.
IRB 2600ID:
The oil plug, venting can stay seated until
the wrist is rotated.
Turn axis-4 through so that the oil plug on
the side of the wrist points downwards.
IRB 2600ID:
Open the oil plug, venting.
IRB 2600:
Then turn axis-4 another 90°.
IRB 2600:
Let the remaining oil run out through the oil
plug hole, tilthouse.
© Copyright 2009-2023 ABB. All rights reserved.
Note
See the figure in Location of oil plugs on
page 178.
See the figure in Location of oil plugs on
page 178.
Product manual - IRB 2600
3HAC035504-001 Revision: AD