ABB IRB 2600ID Product Manual page 261

Equipment
Other tools and procedures may be re-
quired. See references to these proced-
ures in the step-by-step instructions be-
low.
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Removing complete tubular shaft unit
Use this procedure to remove the complete tubular shaft unit.
1
2
Product manual - IRB 2600
3HAC035504-001 Revision: AD
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
Action
Decide which calibration routine to use, and
take actions accordingly prior to beginning
the repair procedure.
Drain oil from gearbox axis 4.
© Copyright 2009-2023 ABB. All rights reserved.
4.4.2 Replacing complete tubular shaft unit
Note
These procedures include references to the tools
required.
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in Reference calibration
routine on page 413.
Note
How to drain the oil from the gearbox is
described in section:
• Changing the oil, axis-4 gearbox
on page 174
Continues on next page
4 Repair
Continued
261