4 Repair
4.1 Introduction
Structure of this chapter
This chapter describes repair activities for the IRB 2600/IRB 2600 ID. Each
procedure contains the information required to perform the activity, for example
spare parts numbers, required special tools, and materials.
Report replaced units
Safety information
Make sure to read through the chapter
service work.
Product manual - IRB 2600
3HAC035504-001 Revision: AD
WARNING
Repair activities not described in this chapter must only be carried out by ABB.
Note
When replacing a part on the IRB 2600/IRB 2600 ID, report to your local ABB the
serial number, the article number, and the revision of both the replaced unit and
the replacement unit.
This is particularly important for safety equipment to maintain the safety integrity
of the installation.
Note
If the IRB 2600/IRB 2600 ID is connected to power, always make sure that the
IRB 2600/IRB 2600 ID is connected to protective earth and a residual current
device (RCD) before starting any repair work.
For more information see:
•
Product manual - OmniCore V250XT
•
Product manual - IRC5
•
Product manual - IRC5 Panel Mounted Controller
© Copyright 2009-2023 ABB. All rights reserved.
Safety on page 21
before commencing any
4 Repair
4.1 Introduction
191