3 Maintenance
3.3.12 Inspecting Signal lamp (option)
3.3.12 Inspecting Signal lamp (option)
Location of signal lamp
Signal lamp is an option.
Located as shown in the figure.
xx0800000290
A
B
C
D
Required equipment
Equipment
Signal lamp
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Inspecting signal lamp
Use this procedure to inspect the function of the signal lamp.
1
Continues on next page
146
Signal lamp
R3.H1 +, R3.H2 -
R2.CP
R2.CS
Note
If the signal lamp is damaged, it shall be replaced!
Action
Check that the signal lamp is lit when motors
are put in operation ("MOTORS ON").
© Copyright 2009-2013 ABB. All rights reserved.
A
B
C D
Note
For spare parts no. see chapter Spare parts,
section:
•
Spare parts options on page 368
Content is defined in section
on page
341.
These procedures include references to the
tools required.
Note
3HAC033453-001 Revision: H
Standard tools